Sharp UX-177 Service Manual page 28

UX-177H
Jamming releasing method
The method to release the cutter-provided mode) is explained.
1
During ordinary operation, cutting becomes impossible be-
cause of plural sheet feed or similar.
2
After the error sound, "CUTTER RESETTING" is displayed.
3
Try automatic cutting.
4
"PAPER JAM" is displayed whether cutting is possible or not.
Cutting is possible.
5
Open the cover of the recording paper, and remove the
jammed, chipped or similar paper.
6
Reset the recording paper, and close the cover of the record-
ing paper.
7
It stands by.
(Paper is jammed)
Moving blade of cutter
Jammed paper
Recording paper guide (lower)
Fixed blade of cutter
Cutter guide (upper)
Rear cover B
Pencil or similar wooden rod
Rear cover B
Fig. 9
Cutting is impossible.
5
Open the cover of the recording paper, and remove the
jammed, chipped or similar paper.
6
Press the start or stop key.
7
Reset the machine (Same as in Item
8
Remove the chipped paper.
9
Reset the recording paper, and close the cover of the record-
ing paper.
F
It stands by.
Cutting is impossible even after jamming is released.
G
Insert the wooden rod or similar (example: pencil) through
the paper discharge port, move the moving blade upward
and remove the jammed paper.
Note: Don't insert any metallic rod.
(See the appended drawing.)
(Jamming is released.)
Remove the jammed paper.
Sheet metal
Wooden
Resin
3 – 4
3
.)
Fig. 10