Mixer Mode Settings - Casio CTK-691 User Manual

CTK691E01-01.book 55 ページ ２００３年９月２９日 月曜日 午後４時４７分
5.
Play something on the keyboard.
You can also record Auto Accompaniment
chords by selecting the applicable mode with the
MODE button.
Optional pedal operation is also recorded. See
"Track 1 Contents After Real-time Recording".
6.
Press the START/STOP button to end
recording when you are finish playing.
If you make a mistake while recording, you can
stop the record operation and begin over again
from step 1, or you can use the editing function
(page E-62) to make corrections.
Using real-time recording to record to a track that already
contains recorded data replaces the previous recording
with the new one.
Track 1 Contents After Real-time Recording
In addition to keyboard notes and accompaniment chords,
the following data is also recorded to Track 1 during real-time
recording. This data is applied whenever Track 1 is played
back.
Tone number
Rhythm number
INTRO/ENDING 1 button, INTRO/ENDING 2 button,
VARIATION/FILL-IN 1 button, VARIATION/FILL-IN 2
button, SYNCHRO/FILL-IN NEXT button operations
Pedal operations (option)
The following data is recorded in the header whenever you
start a recording of a track.
Mixer settings of other tracks
Effect type
Accompaniment volume
Reverb Level
Chorus Level
DSP Hold On/Off
Mixer Hold On/Off
705A-E-057A
Song Memory Function

Mixer Mode Settings

Channel 1 Mixer parameters (page E-39) are automatically
recorded to Track 1. You can use the Mixer to change each of
the parameters.
Memory Capacity
The keyboard has memory for approximately 10,000 notes.
The measure number and note number flash on the
display whenever remaining memory is less than 100
notes.
Recording automatically stops (and auto-accompaniment
and rhythm stops playing if they are being used)
whenever memory becomes full.
Initially, nothing is stored in song memory.
Memory Data Storage
Whenever you make a new recording, anything
previously stored in memory is replaced.
Turning off the keyboard while a record operation is in
progress causes the contents of the track your are
currently recording to be lost.
Remember that you can dump memory contents to
another MIDI device using the procedure described
under "Using the Data Download Service" on page E-82.
Track 1 Real-time Recording Variations
The following describes a number of different variations you
can use when recording to Track 1 using real-time recording.
All of these variations are based upon the procedure
described under "To record with real-time recording" on
page E-54.
To start recording with synchro start
In place of step 4, press the SYNCHRO/FILL-IN NEXT
button. Auto-accompaniment and recording will both start
when you play a chord on the accompaniment keyboard.
To record using an intro, ending, or fill-in
During recording, the INTRO/ENDING 1/2, SYNCHRO/
FILL-IN NEXT, and VARIATION/FILL-IN 1/2 buttons (pages
E-35 to E-36) can all be used as they normally are.
E-55