Track Contents After Real-Time Recording; To Record To Tracks 2 Through 6 - Casio CTK-691 User Manual

CTK691E01-01.book 60 ページ ２００３年９月２９日 月曜日 午後４時４７分
Song Memory Function

Track Contents After Real-time Recording

In addition to keyboard notes, the following data is also
recorded to the selected track during real-time recording.
This data is applied whenever the track is played back.
Tone number
Optional pedal operations
The following data is recorded in the header whenever you
start a recording of a track.
Mixer settings of other tracks
Effect type
Accompaniment volume
Reverb Level
Chorus Level
DSP Hold On/Off
Mixer Hold On/Off
To record to Tracks 2 through 6 using step
recording
This procedure describes how to input notes one-by-one,
specifying each note's pitch and length.
1.
Press the SONG MEMORY button three times
to enter real-time record standby, and then use
the number buttons to select a song number (0
to 4).
The song number you select should be the one
where you previously input Track 1.
2.
Use the SONG MEMORY TRACK buttons to
select the track you want to record to (2 through
6).
Example:
Select Track 2.
Flash
1
E-60
3.
Specify a tone number.
Pressing a TONE button or the DRAWBAR
ORGAN button displays the tone number and
name on the display. You can then use the
number buttons, or the [ + ] (increase) and [–]
(decrease) buttons to change the tone.
After changing the tone number, press any
keyboard key to clear the tone number and name
screen, and return to the note input screen.
4.
Use the keyboard keys to input notes, or the [0]
button to input rests.
At this time, the display shows the keyboard
pressure (velocity). Use the [ + ] (increase) and [–]
(decrease) buttons to change the velocity.
You can also input a chord.
5.
Use the number buttons to input the length of
the note or rest (page E-58).
6.
Repeat steps 4 and 5 to input more notes.
7.
Press the START/STOP button to end
recording when you are finished.
Use the procedure under "Correcting Mistakes While Step
Recording" on page E-61 to correct input mistakes you
make during step recording.
You can add on to a track that already contains recorded
data by selecting that track in step 2 of the above
procedure. Doing so automatically locates the step
recording start point at the first beat immediately following
the previously recorded data.
Whenever you are recording to Tracks 2 through 6, the
entire keyboard functions as a melody keyboard,
regardless of the current MODE button setting.
Track Contents After Step Recording
In addition to notes and rests, the following data is also
recorded to the track during step recording. This data is
applied whenever the track is played back.
Tone number
705A-E-062B