Table of Contents
Advertisement
List of Setting Items
The following items related to the Double Tray Stacker can be specified on the [Maintenance] screen and the
[Admin Menu] screen.
• The factory settings are underlined.
Maintenance
Jogger Setting
Configure whether to vibrate the paper guides (side/end) to improve the
alignment of printouts.
• The paper guides (side/end) do not vibrate when printouts are stacked
with offset.
• [Jogger Setting] cannot be changed during printing.
Admin Menu
■ Printer
Double Tray Stacker
Configure to which position the stacking tray is lowered when the system
finishes or pauses the job that outputs paper to the Double Tray Stacker.
Touch [Unit1] to configure the left stacker setting. Touch [Unit2] to configure
the right stacker setting.
• When set to [Do not lower], the stacking tray will not be lowered at the
end of the job. This setting is suitable when you output many jobs of
single pages (variable printing) or a small number of printouts. When
you output a small number of printouts, the time for waiting until the
stacking tray returns to the printing position can be shorted.
• When set to [Lower to the carriage], regardless of the number of print-
outs, the stacking tray will be lowered to the carriage at the end of the
job. This will eliminate the need to press the button for lowering the
stacking tray when pulling out the entire carriage for a large amount of
printouts. However, it will not be possible to print the next job until the
printouts are removed and the stacking tray has returned to the printing
position.
• When set to [Lower to the specified position], the stacking tray will be
lowered to the specified position at the end of the job. Use this setting
to configure a position at which you can easily remove the printouts
when not using the carriage.
• When an equivalent of 3,200 to 4,000 sheets has been output to the
stacking tray, the stacking tray will be lowered to the carriage regard-
less of the setting of [Double Tray Stacker].
32
Setting / Description
Setting / Description
Set value / Details
[OFF], [ON]
Set value / Details
[Do not lower],
[Lower to the carriage],
[Lower to the specified position]
Input value: 150 mm - 400 mm (6"
- 15")
(Factory setting: 150 mm (6"))
VALEZUS T2100 User's Guide
Advertisement
Table of Contents
