Services Available From The Admin Mode - Canon AXIS 1650 User Manual

Print Server Management and Configuration

Services Available from the Admin Mode

This Print Server
Print Server Name
System Location
Serial Number
General Settings
Parameter List
Restart
Software Default
44
Click on the Axis logotype to reach Axis' home page.
A click on the question mark will open the print server's help pages.
The following services are available from the Admin mode.
This page contains a section that allows you to view and modify the
general parameter settings of the AXIS 1650. Management operations,
like restarting the AXIS 1650 and resetting its parameters to their default
settings are also available.
This name identifies the print server to the users. The default name is
AXISXXXXXX, where XXXXXX are the last six digits of the print
server's serial number.
This parameter shows where the print server is located, helping you to
find the Canon device you are working with.
Every Axis device is uniquely identified by its serial number. The serial
number is found on the underside label of your print server. See "Print
Server Installation" on page 10.
In this section, you manage the print server's general settings as well as
permissions.
To change the print server's general parameters, select Admin | General
Settings => Change. For additional information, see "Setting General
Parameters" on page 47.
To change print server permissions and restrictions, select Admin |
General Settings => Change and select the Restrictions tab. For additional
information, see "Setting Restrictions" on page 48.
Click Detailed View to see all parameters and their current settings.
Restarts the print server. When the power LED lights constantly and the
Network indicator starts flashing to indicate network activity, the print
server is ready for use again. New configuration settings will then become
active. All contact with the printer server will be lost during a restart.
A Software Default will reset all print server parameters to their factory
default settings except:
• Node address (NODE_ADDR.)
• IP address (IP_ADDR.)
• DHCP enabled or disabled (DHCP_ENABLE.)
A Software Default differs from a Factory Default. A Factory Default is
performed by pressing the Test button, located on the print server, in a
specific sequence. See "The Test Button" on page 61.
When the power LED lights constantly and the Network indicator starts
flashing to indicate network activity, the print server is ready for use
again.
AXIS 1650 User's Manual