Table of Contents
Advertisement
3. Locate the left and right weight-mounting
brackets in loose parts.
4. Install the left bracket to the under side of the
frame using 2 bolts (3/8 x 1-1/4 inches), 2
washers and 2 locknuts (3/8 inch)
Note:
One locknut is from loose parts and the
other is used from earlier removal.
Figure 5
1. Locknut (3/8 inch), existing 5. Hole, existing in frame
2. Forward hole, left side
3. Front left caster (caster
fork and wheel not shown
for clarity)
4. Locknut (3/8 inch), loose
parts
5. On the right side of the machine, install the right
weight-mounting bracket as follows:
•
For machines without a foot assist lift pedal,
secure the bracket using 2 bolts (3/8 x 1-1/4
inches), 2 washers and 2 lock nuts (3/8 inch)
(Figure
6).
Note:
A locknut is from the loose parts and
the other is used from earlier removal.
(Figure
5).
g206982
6. Washer
7. Bolt (3/8 x 1-1/4 inches)
8. Left mounting bracket
1. Front right caster (caster
fork and wheel not shown
for clarity)
2. Forward hole, right side
3. Locknut (3/8 inch), existing 7. Hole, existing in frame
4. Right mounting bracket
Note:
For machines with a foot assist lift
pedal, the washers are not used.
•
For machines with a foot assist lift pedal,
remove the forward fasteners in the foot
assist lift pedal bracket and secure the
bracket using 2 bolts and 2 lock nuts
7).
Note:
One locknut is from the loose parts
and the other is used from earlier removal.
6. Install the weight bracket to the mounting
brackets by aligning the outboard holes in the
bracket with the mounting brackets installed
previously
(Figure
8
Figure 6
5. Bolt (3/8 x 1-1/4 inches)
6. Washer
8. Locknut (3/8 inch), loose
parts
Figure 7
8).
g206981
(Figure
g206980
Advertisement
Table of Contents
