Table of Contents
Advertisement
2
3
1. Rubber hood latch
2. Hood rod end
7. Push the hood latch over the end of the hood
rod as shown in
6
Installing the Chute
Parts needed for this procedure:
1
Chute
1
Knob
1
Carriage bolt (5/16 x 1-3/8 inches)
1
Flange nut (5/16 inch)
Procedure
1. Remove the plate assembly that includes the
side discharge chute
come off at the same time. Save this hardware
and plate assembly.
1
Figure 24
3. Latched position
Figure
24.
(Figure
25). The baffle will
g018363
g018363
1. Flange nuts
2. Plate assembly with
discharge chute
2. Install the existing baffle with the existing bolts
and nuts after removing the plate assembly
(Figure
3. Install a carriage bolt and flange nut into the
front hole show in
5
4
3
1. New flange nut (5/16 inch)
2. New carriage bolt (5/16 x
1-3/8 inches)
3. Existing bolts
4. Align the hole in the chute and install it onto the
bolt. Secure the chute to the mower deck with
the knob and flat washer (5/16 inch)
15
3
Figure 25
3. Carriage bolts
26).
Figure
26.
1
2
Figure 26
4. Existing baffle
5. Existing nuts
1
2
g017834
g017834
g018309
g018309
(Figure
27).
Advertisement
Table of Contents
