Table of Contents
Advertisement
3
Installing the Attachment
Mount
Parts needed for this procedure:
1
Stabilizer bracket (For 2015 and newer models)
2
Carriage bolt (5/16 x 3/4 inch)
4
Locknut (5/16 inch)
2
Self-tapping screw (5/16 x 3/4 inch)
2
Bolt (5/16 x 1 inch)
1
Pivot frame
2
Hairpin cotter
2
Rod
2
Washer
1
Draw-bar decal
For 2015 and Newer Models Only
Note:
The stabilizer bracket is used only on 2015
and newer models (see
1. Install the stabilizer bracket to the engine guard
using two carriage bolts (5/16 x 3/4 inch) and
two locknuts (5/16 inch).
Figure 10
2015 model shown
1. Stabilizer bracket
2. Carriage bolt (5/16 x 3/4 inch)
3. Locknut (5/16 inch)
2. Install the pivot frame to the machine frame.
Secure the pivot frame to the machine frame
Figure
10).
g030494
using two bolts (5/16 x 1 inch) and two locknuts
(5/16 inch).
1. Machine frame
2. Locknut (5/16 inch)
3. Hole
3. Secure the pivot frame to the bottom of the
machine frame using two self-tapping screws
(5/16 x 3/4 inch).
g030494
1. Self-tapping screw (5/16 x 3/4 inch)
2. Pivot frame
4. Attach the draw bar decal 1/2 inch (1.3 cm) to
the left of the attachment mount.
10
Figure 11
4. Bolt (5/16 x 2-1/2 inch)
5. Pivot frame
Figure 12
g028227
g028174
Advertisement
Table of Contents
