Table of Contents
Advertisement
Figure 13
1. Draw bar decal
5. Install the bent, flared end of a rod into the keyed
slot in the left side of the machine frame, and
move the rod rearward to seat it in the frame.
Note:
Repeat this step for the right side of the
machine.
Figure 14
Left side shown
1. Pivot frame hole
2. Washer
3. Hairpin cotter
6. Insert the bent ends of the rods into the
attachment mount as shown in
secure the end of each rod with a washer and
hairpin cotter.
g028305
g028306
4. Support rod
5. Keyed slot, existing
6. Bent, flared end of rod
Figure 14
and
For 2011 through 2014 Models
Only
Note:
The stabilizer bracket is not used on 2011
through 2014 models.
Note:
For 2011 through 2014 models, the rear-engine
guard is optional for this bagger.
1. Install the pivot frame to the machine frame.
Secure the pivot frame to the machine frame
using two bolts (5/16 x 1 inch) and two locknuts
(5/16 inch).
1
g030496
1. Machine frame
2. Locknut (5/16 inch)
3. Hole
2. Secure the pivot frame to the bottom of the
machine frame using two self-tapping screws
(5/16 x 3/4 inch).
11
2
3
4
Figure 15
4. Bolt (5/16 x 2-1/2 inch)
5. Pivot frame
6. Rear-engine guard
(optional)
5
g030496
Advertisement
Table of Contents
