Table of Contents
Advertisement
1
Figure 16
1. Self-tapping screw (5/16 x 3/4 inch)
2. Pivot frame
3. Attach the draw-bar decal 1/2 inch (1.3 cm) to
the left of the attachment mount.
g030498
Figure 17
1. Draw bar decal
4. Install a bent, flared end of a rod into the keyed
slot in the left side of the machine frame, and
move the rod rearward to seat it in the frame.
Note:
Repeat this step for the right side of the
machine.
1. Pivot-frame hole
g030497
2
2. Washer
g030497
3. Hairpin cotter
5. Insert the bent ends of the rod into the
Assembling the Bagger Top
Parts needed for this procedure:
Procedure
1
Turn the bagger top over. Install the screen as shown
g030498
in
Figure 19
bags. Make sure the screens snap into place and the
tabs engage the bagger top.
12
2
1
4
6 5
Figure 18
Left side shown
attachment mount and secure the end of each
rod with a washer and hairpin cotter as shown
in
Figure
18.
4
1
Bagger top
1
Bagger screen
so it slopes down toward the collection
3
g030499
g030499
4. Support rod
5. Keyed slot (existing)
6. Bent, flared end of support
rod
Advertisement
Table of Contents
