Safety Information - Weller WTQB 1000 Original Instructions Manual

GB
ENGLISH
Read these instructions and the safety
guidelines carefully before starting up the unit
and starting work.
The installation and commissioning of the equipment
supplied by us must be restricted to authorized person-
nel.
Failure to observe the safety regulations results in a risk to
life and limb.
Keep these instructions in a place that is accessible to all
users.

Safety information

For safety reasons, children and youths
under the age of 16, as well as per-
sons who are not familiar with these
operating instructions, may not use the
device. Children shall not play with the
appliance.
This device is not intended for use by
persons (including children) with limited
physical, sensory or mental aptitude,
or by persons who lack knowledge or
experience in handling the device.
Keep other persons well away from your workplace.
The work area is out of bounds for children and unauthorised
persons. Never allow other persons to touch the soldering
tool or cable.
WARNING Danger of injury
The device or parts of the device may fall off during trans-
portation.
Carrying along metal parts and watches is prohibited.
Persons with cardiac pacemakers or other medicinal
implants may not use this drill stand.
Persons with cardiac pacemakers or other medicinal
implants may not use this drill stand.
WARNING Danger of crushing
Magnetic PCB holder can get dressed and grab another.
Keep magnetic components separated.
•
Always remain the PCB jams on the work surface.
•
Put the PCB jams not too close together.
•
20
WARNING Electrical shock
Connecting the control unit incorrectly poses a risk of
injury due to electric shock and can damage the device.
Carefully read the attached safety information, the safety
•
information accompanying these operating instructions as
well as the operating instructions for your control unit before
putting the control unit into operation and observe the
safety precautions specified therein.
Only connect WELLER tools.
•
If the device is faulty, active electrical conductors may be
bare or the PE conductor may not be functional.
Repairs must always be referred to a Weller-trained
•
specialist.
If the electrical tool's power supply cord is damaged, this
•
must be replaced with a specially prefabricated power
supply cord available through the customer service
organisation.
Protect yourself against electric shocks. The handles on
soldering tools with an antistatic design are conductive.
Avoid touching earthed objects such as pipes, heaters,
•
cookers and refrigerators..
Do not use the soldering tool in a damp or wet environment.
•
Never work on voltage-carrying parts.
•
WARNING Fire hazard
Covering the soldering iron or the safety holder poses
a fire hazard. Always keep objects well away from the
soldering iron and safety holder.
Always keep objects well away from the soldering iron
•
and safety holder.
Keep all combustible objects, liquids or gases well away
•
from the hot soldering tool.
Do not place any flammable material in the vicinity of the
•
IR Underheater or the hot air/gas nozzle.
Please use the IR Underheater and Hot Pen only on a
•
level and non flammable Surface.
This equipment must not be switched on or used without
•
supervision.
Do not squeeze the hose of the Hot Air Pen. The
•
interruption of the air flow can cause
overheating of the heating barrel.
•