Accessing The Power Connections - Barco XDX Installation Manual

Installation procedures

4.1 Accessing the power connections

CAUTION: Whenever you access the mains board and thus remove the net input cover, make sure
the projector is disconnected from the power net.
Required tools
Torx screwdriver T20
How to access
1. Remove the back and power side cover of the projector.
2. Slightly loosen the two screws on the bottom of the net input cover (reference 1,
Torx screwdriver.
3. Lift the net input cover up and away from the projector.
Image 4–1 Removal of the net input cover
42 R5914481 /00 XDX
1
Image 4–1). Use a T20