Table of Contents
Advertisement
Starting the projector for the first time
4.
Click on tab Maintenance and select Software update.
5.
Plug a USB device with the downloaded file into the USB port of the Cinema Controller.
Note: The USB device should be formatted in FAT-32. It may only contain the firmware file in the
root level of the device.
The USB device will be detected and a window will prompt in the Web Communicator.
6.
Click Proceed to have the image added in the Manual update section of the page.
Image 5–11 Example of a software package inserted via USB device
7.
Click "Image [name] from the USB device connected to the projector" and confirm.
The software update will start.
Update progress
The update will proceed as follows:
1. The software package will be installed on the projector.
Image 5–12 Example of an update in progress
2. Once the software package has been installed, the following message will be prompted and the projector
will reboot.
Image 5–13 Example of the prompted reboot message
3. Take note: While rebooting, you will lose connection to the projector.
4. Once rebooted, every projector component will be updated to the version included in the software
package. Take into account that it might take a while until all components have been updated.
64
R5914481 /00
XDX
Advertisement
Table of Contents
