Problem And Solution - BorMann BPW3000 User Manual

Use the nozzle cleaner to clean the hose and the water inlet filter.
Change the defective filter.
Make sure that the machine is clean and clean the components when necessary.
Follow the operation-instructions for the different parts. Pluggable ring-nuts are used to
connect the gun, hose and other parts.
The seals of the ring-nut connections shall not be damaged
Turn the detergent tank and fasten it to the foam nozzle.
Connect the foam nozzle with the jet gun.
Turn on the machine. input the cleaning agent by a proportion of 1%. Warning: Use only the
cleaning agent supplied by the manufacturer or their after-sales service.
Keep the appliance safe and store them carefully in a secure dry place. Always store the
machine out of the reach of children.
Avoid storing the washer in temperatures below frost point.
Cut off the power if the appliance malfunctions.

PROBLEM AND SOLUTION

Warning! Disconnect from the electrical power supply before carrying out user maintenance.
If the mains cable is damaged it must be replaced by the manufacturer, or its service agent or
similarly qualified person to avoid a hazard.
Possible problem and solution
Problem
The machine will not
start working.
No enough water
coming out, uneven
working pressure
Probable cause
1. no power supply
2. faulty power supply.
3. locking ring of the pump
too tight.
1. the filter is blocked
2. inlet connection is not
good, air in inlet pipe.
3. the valve is blocked
4. the outlet nozzle is not
smooth.
Possible solution
1. contact the after-sales service
1. Clean the filter.
2. check the connection, tighten the
seal. Check whether the hose is
clogged or whether there is no
enough inlet water.
3. clean the valve and install it again
4. contact the after-sales service