Motor And Feedback Specifications; Table 3-3: Hall-Effect Sensor Specifications; Table 3-4: Thermistor Specifications; Table 3-5: Encoder Specifications - Aerotech ANT95L Series Hardware Manual

ANT95L Hardware Manual

3.3. Motor and Feedback Specifications

Table 3-3: Hall-Effect Sensor Specifications
Supply Voltage
Supply Current
Output Type
Output Voltage
Output Current
Table 3-4: Thermistor Specifications
Polarity
Cold Resistance
Hot Resistance
Note: 1K pull-up to +5V recommended.
Table 3-5: Encoder Specifications
Supply Voltage
Supply Current
Output Signals
Table 3-6: Limit Switch Specifications
Supply Voltage
Supply Current
Output Type
Output Voltage
Output Current
Output Polarity
(Factory Configured)
Note: If the ANT95L is driven beyond the electrical limit, it will encounter a mechanical stop. Impacting the mechanical stop
could cause damage to the stage even at low speeds.
www.aerotech.com
Specification
5 V ±5%
50 mA
Open Collector
24 V max (pull up)
5 mA (sinking)
Specification
Logic "0" (no fault)
Logic "1" (over-temperature fault)
∼100 Ω
∼10 K
Specification
5 V ±5%
250 mA (typical)
Sinusoidal Type (Incremental Encoder): 1 V
signals SIN+, SIN-, COS+, COS- are .5 V
Digital Output (Incremental Encoder): RS422/485 compatible
Specification
5 V ±5%
25 mA
Open Collector
5 V
10 mA (sinking)
Normally Closed (NC)
Sinks current to ground (Logic "0") when not in limit
l
High impedance (Logic "1") when in limit
l
Requires external pull-up to +5 V (10 kΩ recommended)
l
3.3. Motor and Feedback Specifications
into 120 Ω Load (differential
pk-pk
relative to ground.)
pk-pk
29