Final Checks - rotork Pakscan IIS Technical Manual

Pakscan IIS Technical Manual
The screen revealed will be as shown in section 8.5.8. It is possible to enable or disable the requirement for a
PIN or change the Access level from this screen as well as define a new PIN.
The PIN may be placed in or out of use by option 1. A new PIN may be specified using option 2 and the
access level altered using option 3. If the PIN is out of use then the access level is automatically at level 1 - no
restrictions on what may be done via the keypad.
Set the required PIN by pressing '2' and entering the required number. It must be 4 digits in the range 1000 to
9999. Once it is entered make sure that the access level is set correctly.
9.8

Final Checks

Once all the parameters are set, revisit each screen for setting the Ports, Loop, Tags, Time ESD and Access
settings to make sure they have loaded correctly, and that there are no mistakes.
As a final operation make a note of all the settings on a record sheet such as that illustrated in Section 11.
9.9 Downloading Sequence Programmes
Sequences may be downloaded to the master station using either serial comms port. The programme to be
downloaded must be written using the SCT software provided with the sequence option of the master station.
The PC on which this task is performed is then connected to the master station via a serial link. The settings of
the SCT programme require that the address and certain other data about the master station is set into the
configuration. The master station must be set to Generic Modbus protocol on the port that is being used for
communication to the SCT computer.
More information on downloading the programme is available in the SCT guide.
Issue 1.0
Publication S130E 59