rotork IQ Series Instructions For Safe Use, Installation, And Maintenance
Thrust compensator option
Hide thumbs
Also See for IQ Series:
- Manual (9 pages) ,
- Instructions for safe use, installation, basic setup and maintenance (36 pages)
Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for rotork IQ Series
Summary of Contents for rotork IQ Series
- Page 1 IQ Range Thrust Compensator Option Instructions for Safe Use, Installation, and Maintenance This manual contains important safety information. Please ensure it is thoroughly read and understood before installing, operating or maintaining the equipment. PUB002-132-00 Date of issue 04/18...
- Page 2 IQ40 – IQ95 ......8 5. Weights _________________________________9 WARNING: This document must be read in conjunction with the IQ Instructions for Safe Use, Installation, Basic Setup and Maintenance Fig. 1.1 Rotork Thrust Compensator Manual (PUB002-039). IQ3 manual – Section: Introduction...
- Page 3 2.2 Disassembly of bearing 2.3 Reassembly: assembly: IQ10 – IQ35 IQ10 – IQ35 Locate and loosen the locking socket WARNING: Failure to fully clean set screw in the bearing stop ring (7). and grease the drive bush and Thrust O-rings before reassembly could 7.
- Page 4 2.4 Disassembly of bearing 2.5 Reassembly: Torque Locking Socket assembly: IQ40 – IQ95 IQ40 – IQ95 Screw Size lbf.ft 12. Snap Ring Locate and remove the snap ring (12) WARNING: Failure to fully clean 1.62 using a suitable tool. Remove the split and grease the drive bush and 5.75 collar (11).
- Page 5 Mounting the Actuator WARNING: The thrust compensator assembly and WARNING: Refer to the Weights actuator should be fully supported and Measures section in this manual until full valve shaft engagement to ensure correct lifting practices are is achieved and the assembly is followed.
- Page 6 Fitting the Thrust 4.2 Fitting Thrust Compensator to Fit the mounting studs to the actuator Valve Actuator: IQ40 – IQ95 until hand tight. Lower the actuator Compensator onto the thrust compensator and Fit the loose base plate (2) and drive rotate until the mounting studs 4.1 Fitting the Actuator and Thrust bush assembly (3) on to the valve...
- Page 7 Weights Actuator and Thrust Compensator Standard Actuator only: Thrust Compensator only: combination: Weight Weight Weight Actuator Size Actuator Size Actuator Size kg (lbs) kg (lbs) kg (lbs) IQ10 41 (90) IQ10 31 (68) IQ10-18 10 (22) IQ12 31 (68) IQ19-25 16 (35) IQ12 41 (90)
- Page 8 The name Rotork is a registered trademark. Rotork recognises all registered trademarks. The Bluetooth ® word mark and logos are registered trademarks owned by Bluetooth SIG, Inc. and any use of such marks by Rotork is under license. Published and produced in the UK by Rotork Controls Limited. Date of issue 04/18 POWTG0418...
Need help?
Do you have a question about the IQ Series and is the answer not in the manual?
Questions and answers