Activating The Prewash Program; Coin Mode - Electrolux WE1100P Installation Manual

14

6.5 Activating the prewash program

The prewash program is disabled by default. You need to enable it in service mode.
The opening steps are as follows:
1. Press the service switch inside the money box once, all the lights are flashing.
2. Press The Start button once, Heavy and Extra Rinse flash and the screen shows "SE".
3. Press Heavy and Extra Rinse once, the screen displays 00, and then press Heavy and Extra Rinse as "-" and "+"
respectively.
4. Press Extra Rinse until the screen displays 80, and press Start, the screen displays "P2of" (does not open pre-
wash function). Press Heavy or Extra Rinse once, "P2of" change to "P2on", and then pre-wash function of COLD
program is opened.
5. Press the Start button to exit the prewash function setting switch, and press the service switch once to exit the
service mode.
The corresponding service code of the prewashing function is as follows:
1.80 Configure the COLD prewash function, by default, "P2oF" (does not open pre-wash function), can set "P2oN"
(open pre-wash function)
2.81 Configure the WARM prewash function, by default, "P2oF" (does not open pre-wash function), can set "P2oN"
(open pre-wash function)
3.82 Configure the HOT prewash function, by default, "P2oF" (does not open pre-wash function), can set "P2oN"
(open pre-wash function)
4.83 Configure the DELICATE prewash function, by default, "P2oF" (does not open pre-wash function), can set
"P2oN" (open pre-wash function)

6.6 Coin Mode

The machine is default OPL mode. You can easily change to COIN mode by following steps:
1. Press the service switch, the lights will flash and the display will show "8888".
2. Press the "Cold" button, then press the "Start" button. The display will show "00.00".
3. Then you can set the price through the button (Cold/Warm/Hot/Delicate).
4. After the price setting is done, press the "Start" button to save it.
1 Service Switch
Installation manual
1
fig.W01598