U-Line H-7505 Quick Start Manual

H-7505
BATTERY-POWERED
PALLET TRUCK
OPERATING ISSUE
Unit does not power on
when battery is inserted.
Battery is not holding a
charge.
Unit only lifts on one side.
Deadman Switch Error F2,1
Emergency Reverse Switch
Error F2,2
If the problem persists, or if the troubleshooting section does not resolve or describe your problem, contact Uline
Customer Service at 1-800-295-5510.
PAGE 1 OF 3
1-800-295-5510
uline.com
TROUBLESHOOTING
CAUSES
Battery is not fully inserted
into the cradle.
Pins are broken, stuck or
missing.
Wall power outlet may not
be good.
The charger cord needs to
be inspected.
Pins are broken, stuck or
missing.
Long rods may have come
unbolted.
Deadman switch needs to
be adjusted or replaced.
Red emergency reverse
button is jammed.
Para Español, vea página 2.
Pour le français, consulter la page 3.
RECOMMENDATIONS
Ensure battery is fully inserted into the
cradle. If fully inserted and unit is still
not powering on, check pins as noted
in next potential cause.
Check pins in battery cradle. Replace
any broken pins and ensure the
broken pins are not stuck in battery.
Turn power on unit and verify fuel
gauge illuminates. If it does, the unit is
good. Otherwise, use another power
outlet.
Check the A/C charger cord by
performing a voltage test. If there
is an issue, the cord needs to be
replaced.
Check pins in battery cradle. Replace
any broken pins and ensure the
broken pins are not stuck in battery.
Check long rods under forks to
ensure they have not come unbolted.
Reattach as needed.
Ensure handle is completely upright
when turning on unit. Adjust or
replace deadman switch as needed.
Check red emergency reverse button
and ensure it is not wedged in place.
0321 TH-7505