Is There A Problem - TEFAL STEAM N PRESS DV86 Series Manual

Warning: never forget to unplug the steam brush and empty the water in horizontal
position after your ironing session. While not in use, you can hang your steambrush by
its hook. Wait for an hour before hanging.
Please note that water can come out of the inlet cover if you hanging it vertically.

IS THERE A PROBLEM ?

Problems
There is no steam.
The appliance does
not heat.
Water leaks or spits.
The steam leaves
stains on the fabric.
Possible causes
The steamer is not plugged
in.
The water level is too low.
The steam button trigger
has not been primed.
You use the appliance for
the first time.
The water tank is not in
place.
The appliance is not hot
enough.
The appliance is jammed
by calc.
It is not plugged in.
The water tank is not in
place.
Your appliance is not hot
enough.
You are using water with
additives.
Check that your appliance is
correctly plugged in.
Remove tank and refill it.
Press the steam button trigger
successively for a few seconds to
begin steaming.
When the appliance is new, press
the steam button trigger a few
times.
Ensure that the water tank snaps in
when put into place (full lock).
Plug in your appliance.
Adjust temperature dial and wait for
stable temperature.
Apply "Maintenance descaling
procedure".
Allow your steam brush to heat for
approximately 60 seconds before
using.
Ensure that the temperature dial is
at 3 dots or more.
Wait for 60 seconds so that the
appliance is ready to steam.
Never add any product additives in
the water tank.
9
Solutions