Wipers And Washers - Honda HR-V 2018 Manual

uuOperating the Switches Around the Steering WheeluWipers and Washers

Wipers and Washers

■
Windscreen Wipers/Washers
a
b
c
d
e
Pull to
use
washer.
Intermittent Time
Adjustment Ring
a MIST
b OFF
c INT *2 /AUTO *3
LO: Low speed wipe
d
e HI: High speed wipe
*1: Models with the keyless access system have an ENGINE START/STOP button instead of an
ignition switch.
*2: Models without automatic intermittent wipers
*3: Models with automatic intermittent wipers
* Not available on all models
210
The windscreen wipers and washers can be
used when the ignition switch is in ON
INT
■
MIST
The wipers run at high speed until you release
the lever.
■
Wiper switch (OFF, INT
Change the wiper switch setting according to
the amount of rain.
■
Adjusting wiper operation
Turn the adjustment ring to adjust the wiper
*
operation.
Lower speed, fewer sweeps
Higher speed, more sweeps
■
Washer
Sprays while you pull the lever towards you.
When you release the lever for more than one
second, the spray stops, the wipers sweep two
or three more times to clear the windscreen,
then stop.
1Wipers and Washers
NOTICE
Do not use the wipers when the windscreen is dry.
w ( *1 .
The windscreen will get scratched, or the rubber
blades will get damaged.
NOTICE
/AUTO , LO, HI) In cold weather, the blades may freeze to the
*2 *3
windscreen.
Operating the wipers in this condition may damage
the wipers. Use the demister to warm the
windscreen, then turn the wipers on.
*
Models with intermittent time adjustment ring
If the vehicle speeds up while the wipers are
operating intermittently, the length of the wipe
interval shortens.
When the vehicle speeds up, the wiper operation's
shortest delay setting (
the same.
NOTICE
Turn the washers off if no washer fluid comes out.
The pump may get damaged.
The wiper motor may stop motor operation
temporarily to prevent an overload. Wiper operation
will return to normal within a few minutes, once the
circuit has returned to normal.
) and the LO setting become