Honda HR-V 2018 Manual page 209

uuOperating the Switches Around the Steering WheeluAuto High-Beam (High Beam Support System)
■
Operating the System
The high beams remain on unless:
• You have been driving below 24 km/h for an extended amount of time.
• The speed of the vehicle drops below 10 km/h.
• The windscreen wipers have been running at a high speed for more than a few
seconds.
• You enter a well lit location.
The high beams come back on once the condition that caused them to turn off no
longer exists.
If needed, you can temporarily turn the system off manually. Turn on the high
beams by pushing the lever forward until you hear a click, or flash the high beams
once by pulling the lever toward you. To turn the system back on, pull and hold the
lever towards you for a few seconds.
208
To activate the system, turn the headlight
switch to AUTO and then set the headlights
to low beam. The auto high-beam indicator
will come on.
2 Light Switches P. 200
Headlight
Switch
*
1Operating the System
For the auto high-beam to work properly:
•
Do not place an object that reflects light on the
dashboard.
•
Keep the windscreen around the camera clean.
When cleaning the windscreen, be careful not to
apply the windscreen cleanser to the camera lens.
•
Do not attach an object, sticker or film to the area
around the camera.
•
Do not touch the camera lens.
If the camera receives a strong impact, or repairing of
the area near the camera is required, consult a dealer.
If the message appears:
•
Use the climate control system to cool down the
interior and, if necessary, also use demister mode
with the air flow directed towards the camera.
•
Start driving the vehicle to lower the windscreen
temperature, which cools down the area around
the camera.
If the message appears:
•
Park your vehicle in a safe place, and clean the
windscreen. If the message does not disappear
after you have cleaned the windscreen and driven
for a while, have your vehicle checked by a dealer.