Honda HR-V 2018 Manual page 84

7. Let the seat belt retract a few centimetres
and check that the retractor has switched
modes by pulling on the webbing. It
should not pull out again until it is reset by
removing the latch plate from the buckle.
u If you are able to pull the shoulder belt
out, the lockable retractor is not
activated. Slowly pull the seat belt all
the way out, and repeat steps 5 – 6.
8. Grab the shoulder part of the seat belt
near the buckle, and pull up to remove
any slack from the lap part of the belt.
u When doing this, place your weight on
the child restraint system and push it
into the vehicle seat.
9. Position the belt properly. Make sure the
belt is not twisted.
While pulling down the tab, pull up the
u
upper shoulder part of the belt to
remove any slack from the belt.
uuChild SafetyuSafety of Infants and Small Children
1Installing a Child Restraint System with a Lap/Shoulder Seat Belt
A child restraint system that is not properly secured
will not adequately protect a child in a crash and may
cause injury to the child or other vehicle occupants.
Lap/shoulder seat belt with lockable retractor
After the child restraint system is installed properly,
check if the lockable retractor is activated and the
belt is fully retracted and locked. To deactivate a
lockable retractor, release the buckle and allow the
seat belt to wind up all the way.
Continued 83