Replacing The Nozzle - Viessmann VITOFLAME 100 Service Instructions Manual

Initial start−up, inspection and maintenance
Further details regarding the individual steps

Replacing the nozzle

14
1. Remove sensor plate A from the
blast tube connection.
2. Replace nozzle B (prevent the
A
blast tube connection from
turning); during this step prevent
air bubbles from forming in the
blast tube connection.
For make and type of nozzle, see
standard burner settings on
page 38.
3. Fit sensor plate A.
Position the nozzle in the centre of
B
the sensor plate and observe the
clearance between the sensor
plate and the nozzle (see page 15).
(cont.)