Garmin GPS 95 STD Personal Navigator Owner's Manual page 62

To set the alarm clock...
· Highlight the alarm clock time and enter the desired alarm time. NOTE:
The alarm time may be either UTC or local time depending on the
setting on the Date/Time Page. (See Section 8.9.)
· Press ENT.
· The on/off cyclic field is highlighted. If the alarm is not turned on, press
CLR.
The graphic CDI may be configured to the desired scale and steering
orientation. Scale settings of ±.25, 1.25, or 5.00 units (nautical miles, statute
miles, or kilometers) are available. The scale setting represents the distance
from center of the CDI to either end.
To set the CDI scale...
· Highlight the CDI scale field.
· Press CLR to select the desired scale.
The CDI "Steer To" orientation determines how you interpret the "D-Bar"
when it moves. You may select a "Steer to >Center" or "Steer to >D-Bar"
orientation. A "Steer to Center" orientation, in effect, displays your position
as the "D-Bar" and the center of CDI is the desired track. Thus, when you
are off course, you would steer towards the center of the scale. A "Steer to
D-Bar" orientation is just the opposite. The "D-Bar" represents the desired
track and the center of the scale represents your position. When you are off
course, you then steer towards the "D-Bar". A "Steer to D-Bar" orientation
is the typical setting for aviation use and will make the GPS 95's graphic CDI
respond much like the CDI on your instrument panel.
To set the CDI orientation...
· Highlight the "steer to" field.
· Press CLR to select the desired orientation.
8-9