Building Routes With Autostore - Garmin GPS 95 STD Personal Navigator Owner's Manual

Garmin gps 95std: owners manual

Table of Contents

You may capture and save your position as a waypoint, without adding it to

a route, by leaving the route storage number field blank.

To capture present position ...

· Press AUTOSTO. The pre-assigned waypoint identifier and captured

position are displayed. (NOTE: The Autostore

as soon as you press AUTOSTO. This allows you all the time you need

to change the waypoint identifier and/or confirm the Autostore

operation.)

· If you wish to assign a different identifier to the waypoint: move the

cursor to the waypoint identifier field, enter the name of your choice and

press ENT. If you enter a waypoint identifier already used, you will be

informed with the message, "WPT Exists _____" (where the blank will

be filled in with the waypoint identifier). Enter a different identifier if this

occurs.

· Press ENT on a blank route storage number field to save the waypoint.

(If the route storage number field is not blank, the waypoint will be

added to the route shown.)

7.2 BUILDING ROUTES WITH AUTOSTORE

The GPS 95's Autostore

are flying. During your flight; as you reach each airport, NAVAID, landmark,

or turn to a new heading; you may capture your position and add it to a route.

Once you reach your destination you can then invert the route and follow the

same course back to where you started. Or, you may want the route for future

reference if you wish to make the same flight again.

7-2

feature may also be used to build a route as you

location is captured

Table of Contents