Table of Contents
Advertisement
Press and lift the tab on the lid of
1.
the rinse aid container .
Top up the rinse aid up to the max
2.
mark.
If rinse aid has spilled over, it must
3.
be removed from the rinse aid
container.
Rinse aid spilled over can cause
excessive foaming during the wash
cycle.
Close the lid of the rinse aid
4.
reservoir.
a The lid audibly clicks into place.
Set rinse aid amount
If streaks or water spots remain on
the dishes, adjust the amount of rinse
aid.
on
to press.
1.
2
1
max
Approx. 3 seconds on
2.
to access the basic settings.
a The display shows Hxx.
a The display shows
to give.
Just as often on
3.
until the display shows the
factory-set value r05.
Press as many times until
4.
the desired amount of rinse aid
has been set.
– A low setting adds less rinse aid
during the wash cycle, which
reduces the streaks on the
dishes.
– A higher setting adds more rinse
aid during the wash cycle,
reducing water spots and
improving drying results.
To save the settings, press for
5.
approx. 3 seconds.
Switch off the rinse system
If the rinse aid refill indicator bothers
you, eg if you use a combined
dishwasher detergent with a rinse aid
component, you can switch off the
rinse aid system.
Tip: The function of the rinse aid is
limited in combined detergents. You
usually get better results by using
rinse aid.
on
to press.
1.
Approx. 3 seconds on
2.
to access the basic settings.
a The display shows Hxx.
Rinse System NL
reflected
to press
Busy-
Busy-
29
Advertisement
Table of Contents
