Table of Contents
Advertisement
NL Set up and connect
During the drying phase, moisture
from the wash chamber is stored in
the mineral and heat energy is
released. The heat energy is blown
out into the wash cabinet with dry air.
This allows fast and improved drying.
Drying with zeolite is therefore
very energy-saving.
Tip: For proper drying with zeolite, do
not place dishes directly in front of
the suction opening and discharge
opening of the zeolite reservoir.
Do not place temperature-sensitive
crockery directly in front of the outlet
opening of the zeolite container.
→ "Device", Page 16
Aquasensor
The aquasensor is an optical
measuring device (photocell) with
which the turbidity of the washing
water is measured. Water can be
saved with the aqua sensor.
The use of the aquasensor depends
on the specific program. In case of
heavy soiling, the washing-up water is
pumped out and replaced with fresh
water. In the case of light soiling, the
washing water is also used during the
next washing phase and the water
consumption can be reduced by 3-6
litres. In the automatic programs, the
temperature and running time are
also adapted to the degree of soiling.
14
Set up and connect
s Connect the appliance to electricity
and water in a professional manner
for correct use. Observe the required
criteria and the installation
instructions.
Scope of supply
After unpacking, check all parts for
transport damage and for
completeness of the delivery.
For complaints, please contact the
store where you purchased the
device or our customer service.
Note The device has been checked at
the factory for correct operation.
Water stains may remain on the
device. The water spots disappear
after the first wash cycle.
The delivery consists of:
s Dishwasher
s Instructions
s Assembly instructions
s Guarantee
s Mounting material
s Steam protection plate
s Power cord
s Quick guide
Setting up and connecting the
device
You can install your under-counter or
built-in appliance in the kitchen unit
between wooden and plastic walls. If
you subsequently install the device as
a free-standing device, you must
secure the device against tipping over,
e.g. by screwing it to the wall or
installing it under
Advertisement
Table of Contents
