Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for Bosch SMV65E00GB
Summary of Contents for Bosch SMV65E00GB
- Page 2 6WDUW...
-
Page 3: Table Of Contents
Table of contents Cups and glasses ....13 Intended use ....4 Pans . -
Page 4: Intended Use
Intended use Cleaning and maintenance . . . 24 Intended use Overall condition of the machine . . . 24 u s e I n t e n d e d Special salt and rinse aid ..24 This appliance is intended for Filters . -
Page 5: Delivery
Safety instructions Delivery Ensure that the protective conductor system 1. Check the packaging and of the domestic supply has dishwasher immediately for been correctly installed. damage caused in transit. Do The electrical connection not switch on a damaged conditions must correspond appliance, but contact your with the specifications supplier. -
Page 6: In Daily Use
Safety instructions After installing the appliance, Damage ensure that the plug is easily The appliance may be accessible. repaired and opened up by a (See Electrical connection) technician only. To do this, Some models: disconnect the appliance The plastic housing on the from the power supply. - Page 7 Safety instructions Do not lean or sit Do not allow children to play on the open door. with or operate the appliance. In the case of free-standing appliances, ensure that the Keep children away from baskets are not overloaded. detergents and rinse aid. These may cause chemical If the appliance burns in the mouth, throat...
-
Page 8: Protection Of The Environment
Protection of the environment Protection of the Getting to know your environment appliance o n m e n t t h e e n v i r i o n o f P r o t e c t a p p l i a n c k n o w y o u r n g t o G e t t i... -
Page 9: Appliance Interior
Water softening system/Special salt Appliance interior Water softening system/Special salt 1" Interior light * s a l t e m / S p e c i a l n g s y s t s o f t e n i W a t e r 1* Top basket To ensure good washing results,... -
Page 10: Water Hardness Table
Water softening system/Special salt Using special salt To change the setting: 1. Press programme button 3. Always refill with special salt Each time the button is pressed, the immediately before switching on the set value increases by one level; appliance. This ensures that overrun when the value of : has been special salt solution is immediately... -
Page 11: System
Rinse aid 1. Open the dispenser 9" by pressing Switching off salt refill and lifting the plate on the cover. indicator/water softening system Sw i t c h i n g of f w a t e r so f t e n i n g s y s t e m If the salt refill indicator @ is impaired (e.g. -
Page 12: Setting Amount Of Rinse Aid
Utensils Setting amount of rinse aid Switching off rinse aid refill indicator The amount of rinse aid can be set from . Please set rinse aid on If the rinse-aid refill indicator H is to obtain very good drying results impaired (e.g. -
Page 13: Loading The Dishwasher
Utensils Cups and glasses Recommendation: Use only glasses and porcelain Top basket 1* which the manufacturer designates as dishwasher-proof. Use a detergent which protects utensils. Take glass and cutlery out of the dishwasher as soon as possible after the programme ends. Loading the dishwasher 1. -
Page 14: Cutlery Basket
Utensils * Depending on the model, a 3-fold height adjustment is possible. To do Other examples, such as the best way this, first place the etagere vertically of loading your dishwasher, can and pull up, then place at a slight angle, be found on our homepage as a free push down to the required height (1, 2, download. -
Page 15: Knife Shelf
Utensils Knife shelf * Top basket with side levers K n i f e s h e l f 1. Pull out the top basket 1* out. * depending on model 2. To lower the basket, press in the left Long knives and other utensils can be and then the right lever on the arranged horizontally. -
Page 16: Detergent
Detergent Adding detergent Detergent 1. If the detergent dispenser 9* is still D e t e r g e closed, press the lock 92 to open You can use tablets as well as powder or liquid detergents for dishwashers, but the detergent dispenser. -
Page 17: Combination Detergent
Detergent Notes If the utensils are only lightly soiled, You will obtain optimum rinsing slightly less than the indicated amount and drying results by using solo of detergent is usually adequate. detergents and applying salt and rinse aid separately. Suitable detergents and care products If programmes are short, tablets can be purchased online may not have full cleaning effect... -
Page 18: Overview Of Programmes
Overview of programmes Overview of programmes p r o g r a m m e s O v e r v i e w o f The max. possible number of programmes is illustrated in this overview. The corresponding programmes and their arrangement can be found on the fascia. -
Page 19: Information For Test Institutes
Additional options · Information for test institutes Hygiene * Hy g i e n e Test institutes receive the information for The temperature is increased during the comparability tests (e.g. according to cleaning process. This increases the EN60436). hygiene status. This additional option is ideal for cleaning e.g. -
Page 20: Aqua Sensor
Operating the appliance A qua sensor * Note Aq u a s e n s o r - for environmentally friendly operation * depending on model of the dishwasher: For ecological reasons the Eco 50° The Aqua sensor is an optical programme is preset whenever the measuring device (light barrier) which appliance starts. -
Page 21: Remaining Running Time Display
Operating the appliance 4. Release both buttons. 6. To delete timer programming, press the P + or – button until h : The LED for button # flashes is indicated on the digital display. and the digital display h displays the factory setting : You can change your programme selection at any time until the... -
Page 22: Automatic Switch Off / Interior Light
Operating the appliance Automatic switch off after end To change the setting: 1. Press programme button 3. of programme or interior light* Au t o m a t i c s w i t c h o f f / in t e r i o r l i g h t Each time the button is pressed, the set value increases by one level;... -
Page 23: Interrupting The Programme
Operating the appliance Interrupting the programme Intensive drying 1. Open the door. The final rinse uses a higher temperature which improves the drying 2. Switch off ON/OFF switch (. result. The running time may increase The LEDs go out. The programme is slightly. -
Page 24: Cleaning And Maintenance
Cleaning and maintenance ã Warning – Health hazard Cleaning and Never use other domestic detergents, maintenance e.g. containing chlorine! e n a n c e a n d m a i n t C l e a n i n g Special salt and rinse aid A regular inspection and maintenance of your machine will help to prevent... -
Page 25: Filters
Cleaning and maintenance Filters Spray arms The filters 1Z keep large foreign Limescale and contaminants in the objects in the rinsing water away from rinsing water may block nozzles and bearings on the spray arms 1B and the pump. These foreign objects may occasionally block the filters. -
Page 26: Fault, What To Do
Fault, what to do? 4. Scoop out water, use a sponge if Fault, what to do? required. o d o ? w h a t t F a u l t , 5. Prise out the white pump cover (as illustrated) using a spoon. Grip Experience has shown that you can the cover on the crosspiece and lift rectify most faults which occur in daily... -
Page 27: Fault Table
Fault, what to do? Fault table Fault Cause Remedial action “Check water supply” Supply hose kinked. Install supply hose without kinks. display 8 lights up. Tap turned off. Turn on the tap. Tap jammed or calcified. Turn on the tap. Flow rate must be min. - Page 28 Fault, what to do? Fault Cause Remedial action A different error code is A technical fault has probably Switch off appliances with the ON/OFF switch (. After a short time restart indicated on the digital occurred. display. the appliance. to : If the problem recurs, turn off the tap and pull out the mains plug.
- Page 29 Fault, what to do? Fault Cause Remedial action Utensils not dry. No or too little rinse aid Refill rinse aid. in the dispenser. Programme selected without Select programme with drying (see drying. Overview of programmes, Programme sequence). Water collecting in depressions Arrange utensils in a sloping position, on the utensils and cutlery.
- Page 30 Fault, what to do? Fault Cause Remedial action Food remnants Utensils placed too closely Arrange utensils with adequate clearance on the utensils. together, utensils basket between them ensuring that the spray jets overfilled. can reach the surface of the utensils. Prevent contact points.
- Page 31 Fault, what to do? Fault Cause Remedial action Water stains on plastic Droplet formation on plastic Use a more intensive programme (more parts surface is physically unavoidable. water changes). After drying, water stains are Arrange utensils in a sloping position. visible.
- Page 32 Fault, what to do? Fault Cause Remedial action Coloured (blue, yellow, Film formation consisting Can be partly removed with machine brown), difficult to remove of ingredients from vegetables cleaner or by mechanical cleaning. Coatings to non-removable coatings (e.g. cabbage, celery, potatoes, are harmless.
- Page 33 Fault, what to do? Fault Cause Remedial action Rust spots on the cutlery. Cutlery not adequately rust- Use corrosion-resistant cutlery. resistant. Knife blades are frequently more severely affected. Cutlery will also rust if rusting Do not wash rusting parts. parts are rinsed at the same time (pan handles, damaged utensil baskets, etc.).
- Page 34 Fault, what to do? Fault Cause Remedial action Appliance stops Door not closed properly. Close the door. in the programme or Do not place utensils or fragrance Check whether rear panel is being pressed programme is interrupted. dispenser in the tablet collecting in, e.g.
-
Page 35: Customer Service
Customer service Customer service Installation and connection e r v i c e C u s t o m e r s If you are unable to rectify the fault, i o n a n d c o n n e c t l a t i o n I n s t a l please contact your customer service. -
Page 36: Delivery
Installation and connection Delivery Installation Your dishwasher has been checked The required installation dimensions can thoroughly in the factory to ensure that it be found in the installation instructions. is in working order. This may cause Level the appliance with the aid of the small water stains. -
Page 37: Fresh Water Connection
Installation and connection Fresh water connection Warm water connection * Wa r m wa t e r co n n e c t i o n 1. Connect the fresh-water connection * depending on model to the tap according to the The dishwasher can be connected installation instructions with the to cold or hot water up to max. -
Page 38: Electrical Connection
Installation and connection Electrical connection Removing the appliance Connect the appliance to an Also observe alternating current only, ranging from the sequence of worksteps here. 220 V to 240 V and 50 Hz or 60 Hz 1. Disconnect the appliance from via a correctly installed socket with the power supply. -
Page 39: Transportation
Installation and connection Transportation Protection against frost Pr o t e c t i o n a g a i n s t fr o s t ( E m p t y i n g t h e a p p l i a n c e ) Empty the dishwasher and secure loose If the appliance is in a room where there parts. - Page 41 &KLOGSURRI ORFN GRRU ORFN :DUQLQJ %DNLQJ VKHHW VSUD\ KHDG...
- Page 42 $TXD6WRS JXDUDQWHH 5HSDLU RUGHU DQG DGYLFH RQ IDXOWV 5REHUW %RVFK +DXVJHUlWH *PE+ ZZZERVFKKRPHFRP *9000836605* 9000836605 en (9211) 640MV...