Electrolux MultiSwitch 900 User Manual page 26

7. Remove three 8mm bolts from both
top hinges.
8. To gain access to lower hinge, drawer
will need to be extended. Unscrew
the three lower hinge screws and
slide the hinge inwards Lift up on
door and remove from bottom hinge.
Lower Hinge Removal
CAUTION
Be sure doors are set aside in a
secure position where they cannot
fall and cause personal injury, or
damage to the doors or handles.
9. To reinstall doors, reverse procedure.
IMPORTANT
Make sure water line tubing goes
through hole at top of dispenser
pocket. There is also a metal wrap
on the tubing to prevent damage
from the hinge rubbing against
it. This needs to be fixed back
around the tube in the proper
location upon reinstallation (just
as long as the tube is protected
from the hinge).
NOTE
When reinserting the water tube
and replacing the top hinge cover,
use care to be sure the tube does
not kink.
Once both doors are in place, ensure
they are aligned with each other and
level (Please see the Installation section
for more details), and replace the top
hinge cover.
12.2 To remove the MultiSwitch/
MultiChill drawer
1. Fully open drawer.
2. Remove basket from drawer.
3. Unclip harness at front of drawer
and move harness out of the way
of drawer slides.
4. Press liner clips and slide rail past
clips on both sides to fully remove
drawer from cabinet.
5. Reverse the steps to reinstall
the drawer.
12.3 Removing Freezer Drawer
CAUTION
Drawer is heavy. Use caution
when lifting.
1. Open drawer and fully extend.
2. Remove the freezer drawer.
3. Remove the freezer basket.
4. Inside the cabinet, press the two tabs
on both sides to release the sliders.
EN 25