Before Calling - Electrolux MultiSwitch 900 User Manual

30 www.electrolux.com

15. BEFORE CALLING

Concern
Automatic Ice Maker
Ice maker is not
making any ice.
Ice maker is not
making enough
ice.
Ice cubes are
freezing together.
Potential Cause
• Ice maker is turned off.
• Refrigerator is not connected
to water line or water valve is
not open.
• The water supply line
is kinked.
• The water filter is not seated
properly.
• The water filter may be
clogged with foreign material.
• Ice maker is producing less
ice than expected.
• The water filter may be
clogged with foreign material.
• The water supply line is
kinked.
• Water pressure is extremely
low. Cut-off and cut-on
pressures are too low
(well systems only).
• Reverse osmosis system
is in regenerative phase.
• Ice cubes are not being
used frequently enough
or interruption of power
for prolonged time.
Common Solution
• Turn on ice maker. For the
fresh food ice maker, press
ice maker on-off button once.
• Connect the unit to the
household water supply and
ensure the water valve is
open.
• Ensure that the supply line
does not kink when the
refrigerator is pushed into
place against the wall.
• Remove and re-install the
water filter. Be sure to seat it
fully into the locked position.
• If water dispenses slowly or
not at all, or if the filter is six
months old or older, it should
be replaced.
• The ice maker will produce
approximately 1 kg of ice
(fresh food ice maker)
every 24 hours depending
on usage conditions.
• If water dispenses slower
than normal, or if the filter
is six months old or older,
it should be replaced.
• Ensure that the supply line
does not kink when the
refrigerator is pushed into
place against the wall.
• Have someone turn up the
cut-off and cut-on pressure
on the water pump system
(well systems only).
• It is normal for a reverse
osmosis system to be
below 20 psi during the
regenerative phase.
• Remove ice container and
discard ice. The ice maker
will produce fresh supply. Ice
should be used at least twice
weekly to keep the cubes
separated.