Page 1
ALADIN SERIES FIRMWARE UPDATE PROCEDURE via ANDROID ALADIN SPORT/ONE/HOSE MATRIX, ALADIN A1 & ALADIN A2 A new firmware is available for your ALADIN dive computer. • Make sure your dive computer has enough battery capacity with at least 5 segments.
Page 2
• Click the download link and save the software update (swu) file in your mobile device’s Downloads folder. • To start the software update press the FIRMWARE UPLOAD button, navigate to Downloads folder and select the swu file. SCUBAPRO.COM...
Page 3
• Once the software file has been selected, the update will start. (10) • The status of the software upload is shown on the display with a progress bar. Note: Keep the dive computer near your mobile device while the software update is loading. After successful software upload your dive computer starts the reprogramming automatically.
TROUBLESHOOTING: After the firmware update you may need to unpair your ALADIN dive computer from your mobile device, if Log- TRAK tells you to do so - see the troubleshoot section below for further explanations. Depending on the age and model of your Android device, it might take a couple of retries until 100% upload progress is reached.
Page 5
• Unpair your ALADIN dive computer in your Android’s Bluetooth settings by pressing “Unpair” • Switch Bluetooth OFF and ON again on your mobile device • Scan for available devices • Start the pairing sequence by selecting “Aladin” • Enter the 6-digit pin code •...