Troubleshooting; Maintenance And Cleaning; Cleaning - Labnet Pro 30 Instruction Manual

7.0 Troubleshooting

Should you have a question about the operation of the Labnet Pro 30 Reciprocal Shaker or if service is
required, contact your Corning representative. Do not send in a unit for service without first calling to
obtain a repair authorization number. Should the unit require return to Corning for service, it should
be properly packed to avoid damage. Any damage resulting from improper packaging shall be the
responsibility of the user.
Problem
POWER switch doesn't illuminate
when turned ON.
Shaker doesn't start when you press
START/STOP button.
HOLD yellow signal light and RUN
green signal light are blinking.

8.0 Maintenance and Cleaning

No routine maintenance or lubrication is required.

It is recommended that the shaker is kept clean to ensure long trouble-free operation.


8.1. Cleaning

The housing of the shaker can be cleaned with a soft, damp cloth or special cleaners for plastic surfaces
(e.g. for car interior – armature). Do not immerse the device or spill liquids on the device.
NOTE: Do not use any aggressive or abrasive cleaners (acetone, nitro, polish etc.) because the surface can
get permanently damaged.
Prior to any cleaning or maintenance of the device, unplug the power cord from the wall socket.
Explanation/Solution
Check the connection to main power supply.

Check fuses

Call authorized service

Check the connection to main power supply.

Check fuses

Call authorized service

Motor overload - reduce the load on the platform.

Call authorized service.

Instruction Manual | 3