Table of Contents
Advertisement
Note 9 – Temporary Configuration Flags:
There are some flags that may be turned on to change aspects of the system – the power-up state for all flags is 0 (off).
flg = 1 = Echo-Chars
flg = 2 = Show-Diagnostic-Mssgs
flg = 3 = Leading-Zeroes-in-Mssgs
Note 10 – Zone-Setup Command:
These Setup commands are handy for configuring zones, and are identical to the setup commands available using the RC-16
remote control (shift-pause-#, where # is the sid digit). The zone must be on and not muted to use these commands
sid = 1
sid = 2
sid = 3
sid = 4
sid = 5
sid = 6
sid = 7
sid = 8
sid = 9
Note 11 –Volume Levels (vvl, vvr, vra) are 2-dB/increment (except for 0 = -80dB):
35
+6 dB
34
+4 dB
33
+2 dB
32
0 dB (pass)
31
-2 dB
30
-4 dB
29
-6 dB
28
-8 dB
27
-10 dB
Note 12 – Bass/Treble Levels (bas, trb) are 3-dB/increment:
8
+12 dB
7
+9 dB
6
+6 dB
5
+3 dB
4
0 dB (flat)
3
-3 dB
2
-6 dB
1
-9 dB
0
-12 dB
Set Zone-Initial-Volumes to current left/right levels
Set Zone-Mute-Volume to current (left) level
Set Zone-Min-Volume to current (left) level
Set Zone-Max-Volume to current (left) level
Set Previous-Volume-Flag Off (zone turns on with programmed Initial-Volume level) (normal)
Set Previous-Volume-Flag On (zone turns on at previous level, saved when last turned off)
Set Audio-Mode to Mono
Set Audio-Mode to Stereo (normal)
Restore Zone-Factory-Settings (restored on this one zone only)
26
-12 dB
25
-14 dB
24
-16 dB
23
-18 dB
22
-20 dB
21
-22 dB
20
-24 dB
19
-26 dB
18
-28 dB
When on, RS-232 characters are echoed (for testing only)
When on, diagnostic messages (!S,190 to !S,199) are enabled
When on, message parameters use fixed 3-char format.
17
-30 dB
16
-32 dB
15
-34 dB
14
-36 dB
13
-38 dB
12
-40 dB
11
-42 dB
10
-44 dB
9
-46 dB
28
8
-48 dB
7
-50 dB
6
-52 dB
5
-54 dB
4
-56 dB
3
-58 dB
2
-60 dB
1
-62 dB
0
-80 dB
Advertisement
Table of Contents
