Audio/Video Operation - Vaux Electronics 1600 Series Owner's Manual

Audio/Video Operation

For all operations below, change the RC-16 remote control to the desired zone, if needed. The remote also needs to be in a/v mode
for the following operations: press the RC-16's a/v mode button to change to a/v mode (the button will flash twice). Note: the remote
is automatically placed in a/v mode when you press certain buttons.
Setting the RC-16's Current-A/V-Zone:
•
For all operations below, set the RC-16 remote so you are controlling the desired zone (01 to 90). Press the Zone button,
followed by two-digits corresponding to the desired zone -- eg: Zone-0-1 will select zone 01, and Zone-1-2 will select zone
12. This zone is saved until you change it again.
•
You may also control a Cluster (a group of multiple zones that is programmed into the Lattis system), by selecting zones 91
to 98, for Clusters 1 to 8. Only certain functions are available during Cluster operation.
•
You may also choose zone 00, which is a special All-Zones code. Only certain functions are available during All-Zones
operation.
•
Note: the remote is automatically placed in a/v mode when you press the zone button.
Selecting a Source:
•
Press an RC-16 Source button (Tuner, CD...)
Note: This will automatically place the remote in A/V mode.
•
The Lattis Ack light will flash. The source is routed to the zone at the programmed Initial-Volume-Level for the zone (or,
the Previous-Volume, if the zone is so configured). If the zone is currently on, the new source will be at the current volume
level.
•
The Lattis Active light will be on when any zone is in use.
•
If the Lattis s Nak light flashes, the requested zone is not valid for this Lattis unit. (eg: selecting zone 09 when only 01 to 08
are valid in an 8x8 switcher).
•
If you have a 16-source LE-1600A or LE-1600V, you access the upper sources by pressing the Shift button, followed by a
source button:
button





















 

















 
tuner
cd
dss
vcr1
vcr2
dvd
tape
aux
Turning the Zone Off:
•
Press the RC-16's On/Off button -- the Lattis Ack light flashes, and the zone turns off (note: pressing the On/Off button
again turns the zone on with the previous source).
•
If the Lattis Nak light flashes, the requested zone is not valid for this Lattis unit.
source 1 shift-tuner
source 2 shift-cd
source 3 shift-dss
source 4 shift-vcr1
source 5 shift-vcr2
source 6 shift-dvd
source 7 shift-tape
source 8 shift-aux
source 9
source 10
source 11
source 12
source 13
source 14
source 15
source 16
10