Vaux Electronics 1600 Series Owner's Manual page 23

Miscellaneous Status Messages:
These miscellaneous Status Messages are returned for various system actions:
Sensor-State-Change messages
VI input on I/O jack
Diagnostic messages (normally disabled) !S,190,dgc,opt,0,0 <cr>
Watchdog-Reset occurred
Cmd-Error: Invalid Base-Zone cmd
Cmd-Error: Invalid Cmd-Type
Cmd-Error: Invalid Cmd-Parameter
IR command request
Unknown RC command
Internal diagnostic
!S,180,sen,sst,0,0 <cr>
!S,180,1,sst,0,0 <cr>
dgc is diagnostic-id; opt is option
!S,190,0,0,0,0 <cr>
!S,190,3,0,0,0 <cr>
!S,190,3,1,0,0 <cr>
!S,190,3,2,0,0 <cr>
!S,197,zon,irs,irf,0 <cr>
!S,198,rb1,rb2,rb3,rb4 <cr>
!S,199,p1,p2,p3,p4 <cr>
23
sen is sensor-id; sst is new state
sst=0: VI=low, sst=1: VI=high
(not *CW, *CR, *PW, or *PR)
(invalid cmd-id, wrong number of parameters
bad param value, or checksum error)
(factory-use)
(factory-use)
(factory-use)