Operation - Hilti SCO 6-22 Operating Instructions Manual

1. Press the spindle lockbutton and hold it in this position.
2. Use the hex. wrench to release the clamping nut.
▶ The collet is slack.
3. Remove the tool bit.
5.9 Fall arrest
WARNING
Risk of injury by falling tool and/or accessory!
▶ Use only the Hilti tool tether recommended for your product.
▶ Prior to each use, always check the attachment point of the tool tether
for possible damage.
Comply with the national regulations for working at heights.
As drop arrester for this product, use only a combination of the Hilti retaining
strap and the Hilti tool tether #2261970.
▶ Secure the retaining strap to the installation openings for accessories.
Check that it holds securely.
▶ Secure one carabiner of the tool tether to the retaining strap and secure
the second carabiner to a load-bearing structure. Check that both
carabiners hold securely.
Comply with the operating instructions of the Hilti retaining strap
and those of the Hilti tool tether.
6

Operation

Observe the safety instructions and warnings in this documentation and on
the product.
6.1 Switching on
The on / off switch with switch-on interlock gives you full control of the
switch function and avoids unintentional starting.
1. Push the switch-on interlock forward.
▶ The on/off switch is unlocked.
2. Press the on/off switch as far as it will go.
▶ The power tool's motor runs at no-load speed.
6.2 Holding the product correctly
1. Use clamps or some other practical means to secure the workpiece and
keep it in a stable position.
14 English
6
7
2264442
*2264442*