Advertisement
How to use the dishwasher
1. After loading the dishwasher, close the
door properly and open the water supply
tap.
2. Press the On/Off button to switch the
dishwasher on. One of the programme
indicator lamps will switch on.
3. Select the desired programme by
pressing the corresponding button. The
corresponding indicator lamp lights
up. If required, select options (if
supplied).
4. Press the Start button to start the
selected wash programme. The Start
indicator lamp will light up. Once set,
the programmed data cannot be altered
by pressing the programme selector
buttons.
Note: once the Start button has been
pressed, the dishwasher memorises
the last programme selected. This
information remains in the memory even
during interruption of the power supply.
To change the selected
programme, press the Start button
for about 5 seconds, until the
Start indicator lamp switches
off. Select a new programme
using the programme selector
knob and press the Start button.
Note: If the dishwasher is switched off
during a wash programme, when
switched on again it will resume the
wash cycle from where it was
interrupted.
Only open the dishwasher door if
strictly necessary during a wash
cycle and exercise maximum
caution. Danger of scalding from
steam.
5. To indicate the end of the programme,
the Start indicator lamp switches off and
the End indicator lamp (if fitted) lights
up (for about 30 min.).
6. Once the Start indicator lamp has
switched off press the On/Off button to
switch the dishwasher off. All the
indicator lamps switch off.
7. Open the door (warning: beware of hot
steam). Unload the lower rack before
the upper one. Close the water tap.
Upper rack
Rack height adjustment:
(The dishwasher is delivered with the upper
rack in the top position).
The rack height can also be changed
when loaded.
•
To lower: pull out the two side
handles and gently lower the rack.
•
To raise: pull up the two side handles
until the rack clicks into place.
Please read the user instructions carefully.
Upper and lower rack
•
The rack must be level on both sides.
Crockery Holders:
•
Down: cups and long-stemmed glasses.
•
Up: plates.
"Vario Organizer" multi-purpose support:
•
To be used, for example, for
long-handled utensils (arrange
knives with the blade facing
downwards), cups and glasses.
•
May be used in three different
positions (see also "Dishwasher
loading instructions" on Page 4).
1. Upon the left-hand side of the rack.
2. Upside-down, towards the centre of
the rack.
3. Upside-down, towards the left side.
Glass holder:
Lower rack
B
A
C
Plate holders:
•
May be lowered to increase
available space (A).
•
May be removed to increase
available space (B). To remove:
pull the handle up.
B
A
Cutlery basket:
The cutlery basket can be removed to
increase (C) available space.
C
Advertisement
