Yamaha MZ360 Service Manual page 155

WIRE ROUTING DIAGRAM
1. Spark plug cap
2. Wire harness protector
3. Oil warning unit
4. Engine switch lead (ground)
A. The spark plug cap should face the direction indicated in the illustration.
B. After passing through the lead wire, pull it lightly in the direction of the arrow.
C. Route the lead as shown.
D. The lead is black and the protector is gray.
E. Attach the projection of the oil warning unit to the hole of the bracket.
F. Make sure that the gap between the end of the wire harness protector and end of the crankcase is 5
mm (0.19 in) or more.
G. Fasten the ground terminal and engine switch together.
H. Screw in the high tension cord until it touches the spark plug cap.
Color code
B Black
5. Ground terminal
6. Engine switch
7. Oil warning light
8. High tension cord
B/W Black/White
7-15
1
2
3
4
5
6
7
8
9
10