Advertisement
Loudspeaker System Specifications
Fig. 55 Front LED parameter set to Limit
Push in the "Push for DSP" knob to select the Limit parameter for the Front LED,
and to exit the Config Menu Selection screen, rotate the "Push for DSP" knob till
the arrow in the upper right hand corner turns blue, then press the "Push for
DSP" knob again to return to the Main Menu screen.
About the Limit Function of the PVX™p 10 Bluetooth® Speaker System
Choosing the Limit parameter allows the Front LED mounted on the baffle behind
the grille to flash RED when the sophisticated DSP based compression and
limiting system engages.
Note that this LED indication when the Limit parameter is selected does NOT
indicate amplifier clipping or system distress, it is OK for it to turn RED on a
regular but intermittent basis, as it just confirms that the compression and limiting
system is doing it's job providing as much clean and unclipped output as
possible. However, in the event that the LED is lighting up RED more often than
not, it would be wise to turn down the drive level, so that excess compression
does not occur to the sound.
ABOUT Header
From the Main Start Screen (Fig. 1), you turn the "Push for DSP" knob three
notch's CW, and the About header will be highlighted. See Fig. 56
Fig. 56 About header highlighted
Press in the "Push for DSP" knob, and the About menu will be selected, see Fig.
57
35
Advertisement
