Advertisement
Loudspeaker System Specifications
Check that the input plug is fully seated in the input jack on the rear panel of the
PVX™p 10 Bluetooth®.
Ensure that a power amp has not been plugged into the input jack of the PVX™p
10 Bluetooth®.
If an extension cord is being used to provide the AC power to the unit, insure that
it is of sufficient current capacity and that it is not also being used to supply
power to any other device.
The PVX™p 10 Bluetooth® has built-in EQ to extend and smooth the natural
response of the speakers in the system. If excessive additional bass boost or HF
boost have been added externally to the PVX™p 10 Bluetooth®, it could cause
premature overload at high SPL. Reduce the amount of any external (mixer,
rack) EQ and see if that clears up the distortion.
Finally, realize that even though the PVX™p 10 Bluetooth® is a powerful and
high output unit, it does ultimately have limits, and it may need additional
powered units (or a subwoofer) to provide enough sound output or coverage. In
this case, try turning the mixer levels down a little to see if that clears things up.
If, after checking all the things listed to check and anything else you can think of
to check safely, and the system still exhibits problems, carefully note all
conditions and check with your Peavey dealer for advice.
Care and Maintenance
Your PVX™p 10 Bluetooth® is a sturdy and durable product and will provide
years of reliable use if properly cared for. Use common sense and read the
safety warnings to avoid hazardous operating conditions.
The unit must be disconnected from the AC power source before any work is
done on it. Refer all servicing to qualified service personnel.
Sunlight/Heat
Avoid prolonged exposure to direct sunlight, as this may cause the unit to
overheat and thermally shut off.
Excessively hot operating conditions can also cause a thermal shutdown.
Do not store in extremely hot or cold conditions or extremely high humidity.
Always allow unit to come to room temperature before use.
Cleaning
Never clean the PVX™p 10 Bluetooth® while plugged in or turned ON! When the
unit has been fully disconnected from AC power sources, use a dry cloth to
remove soil or other dirt. Never use strong solvents on the PVX™p 10
Bluetooth®, as they could damage the cabinet. Do not allow ANY fluids to drip
inside the PVX™p 10 Bluetooth®.
39
Advertisement
