Tchibo Esperto Pro Original Instructions For Use And Warranty page 43

WARNING - risk of scalds/burns
• Do not touch the coffee or milk spout during or immediately after use.
Avoid coming into contact with the beverage coming out of the spout.
• The brewing unit becomes hot when preparing beverages.
Do not remove the brewing unit during or shortly after use.
• The surfaces of the heating element stay warm after use.
• If there is too little water in the tank during preparation, the machine
will stop the brewing process.
The brewing process will automatically resume once the water tank
has been filled and reinserted in the machine.
CAUTION – risk of injuries or material damage
• Only use the machine with the container for the coffee grounds
and the leftover water tray inserted.
• Always pour fresh, cold tap or other drinking water into the water tank.
Do not use carbonated mineral water or any other liquids.
• Never fill the coffee bean compartment with raw coffee (green,
unroasted beans), beans that are caramelised or sugar-coated,
beans mixed with raw coffee, or loose coffee powder. Doing so
could damage the machine.
• Grinder settings may only be adjusted while the grinder is in operation.
• Descale the machine as soon as it indicates that this is necessary.
• To move the machine, always hold it by the outer casing.
• To use the machine, place it on a stable, even and horizontal surface
that is well lit and not sensitive to heat or moisture.
• To ensure that the casing does not melt, do not place the machine on
a hob or immediately next to a hot oven, radiator or anything similar.
106466 en Esperto_Pro_v5.indd 43
• Route the connection cable in such a way that it is not a tripping hazard.
Do not let the connection cable hang down over the edge of a table or
counter top so as to ensure that the machine cannot be pulled down by
it.
• Keep all cards with magnetic strips, such as credit cards and debit cards,
away from the drip tray and the cover for the brewing unit and the
magnets built into these parts. The cards could become damaged.
You should also keep magnetic memory storage media and all devices
that are affected by magnetism or may sustain functional impairment
away from the machine.
• The machine is equipped with non-slip feet. Work surfaces often have
varnished or plastic finishes and are treated with a variety of care
products. Some of these may contain substances that react adversely
to the non-slip feet and soften them.
• The machine must not be exposed to temperatures below 4 °C.
Residual water in the heating system could freeze and cause damage.
• Sound pressure level <70dB(A).
43
en
14.06.21 12:24