Test Run - unicraft KW 50 Operating Instructions Manual

Operation
NOTE!
The "automatic shutdown" can be set to the following
values: 0 (never), 5 min, 15 min, 30 min, 60 min.
ATTENTION!
The Auto Off feature maximizes battery life. It starts
the countdown timer if no operation is performed or
the load is stable. When a key is pressed or the load
moves, the countdown timer is restarted.
Power saving mode
Step 1: Press or
ergy saving mode. The display shows
it means that the energy saving mode is set to 30
sec.
Step 2: Press or
change the energy saving mode.
Step 3: Press or
the changes before exiting.
Step 4: Press or
changes before exiting.
NOTE!
The energy-saving mode can be set to the following
values: 0 (never), 5 sec, 15 sec, 30 sec, 60 sec.
ATENTION!
Battery life is maximized by the balance automati-
cally switching to energy-saving mode when no ope-
ration is performed or the load is stable. The balance
is working in energy-saving mode. Each key press or
load movement activates the balance from the
energy saving mode.
Brightness / Backlight
Step 1: Press or
"Brightness / Backlight". The status of the LED
brightness / LCD backlight is displayed.
Step 2: Press or
change the LED brightness / LCD backlight.
Step 3: Press or
the changes before exiting.
Step 4: Press or
changes before exiting.
14
, if you want to start the en-
and , if you want to
, if you do not want to save
, if you want to save the
, if you want to edit the
and , if you want to
, if you do not want to save
, if you want to save the
Display
ATTENTION!
The "display" function allows you to choose between
different qualities of the display presentation as long
as the scale is in motion. The lower the value for the
display level, the faster a weight display will appear,
but the longer it takes for the displayed value to be
stable.
Step 1: Press
"Display" mode. The display shows
means that level 1 is activated.
Step 2: Press
edit the "Display" mode.
,
Step 3: Press
the changes before exiting.
Step 4: Press
changes before exiting.
NOTE!
The display levels for the display can be set to the
following values: 0 (off), 1 (very low), 2 (low), 3 (nor-
mal), 4 (high), 5 (very high).

8.3 Test run

Before operating under load, perform a test run with all
functions tested without load.
8.4 Lift the load upwards
ATTENTION!
- Make sure that there are no people nearby when lif-
ting the crane scale.
- Make sure that the lifting distance of the load is free of
obstacles.
- Avoid putting the load into commuting.
Step 1: Attach the Crane scale to a suitable fixture.
Step 2: Impact the load hook of the Crane scale on a
suitable attachment point of the load and check
that the safety of the hook is closed.
NOTE!
- Check the center of gravity of the attachment point to
prevent movement and slippage of the load.
- Slings (eyelet, chain, etc.) must lie loosely in the hook
base.
- Hook tip may not be loaded.
- Close the fuses.
or , if you want to edit the
or and , if you want to
or , if you do not want to save
or , if you want to save the
KW-Series | Version 1.03
, it