Heinner HWM-V7010D++ Manual page 37

www.heinner.com
FAULT
Your washing is too dirty for the
Unsatisfactory washing
result.
There is too much laundry in your machine.
Unsatisfactory washing
result.
Your laundry is too tightly packed together in
the drum.
As soon as the machine
The end of water drain hose is too low for
is loaded with water,
the machine.
water discharges.
No fault. Water is in the unseen
No water appears in
the drum during
washing.
Laundry has
Non-dissolving particles of some detergents
detergent residue.
may appear on your laundry as white spots. Perform an extra rinse, or clean your laundry with a brush
Grey spots appear on There is untreated oil, cream or ointment
the laundry. on your laundry.
No fault. The Unbalanced load
The spin cycle does not
control system has been activated.
take place or takes place
later than expected.
(*) See the chapter regarding maintenance and cleaning of your machine.
(**) See the chapter regarding installation of your machine.
POSSIBLE CAUSE
programme selected.
Amount of detergent used
insufficient.
Hard water.
part of the drum.
7Kg, 220-240V~50Hz, 1000rpm
TROUBLESHOOTING
Use the information in the programme tables to select the
most appropriate programme.
Use the amount of detergent as instructed on the
packaging.
Check that the maximum capacity for the
selected programme has not been exceeded.
Increase the amount of detergent following the
manufacturer's instructions.
Check that your laundry is spread out.
Check that the drain hose is at a suitable height.
(**) .
. . . . . . . . . . . . . . . . . . . . .
after it dries.
Use the amount of detergent as instructed on the packaging
in the next wash.
The Unbalanced load control system will try to spread your
laundry. The spinning cycle will begin once your laundry is
spread. Load the drum evenly for the next wash.
36