Function Buttons; Controller Start-Up; Switching On / Soft Start - Hasco H1250 Series Operating Instructions Manual

7. Function buttons

On - off button
This activates and deactivates the control unit.
Up - down buttons
Select set point temperature.
Change parameter values.
Manual mode button
Activate manual mode.
Automatic mode / current value button
Activate automatic mode.
Current measurement.

8. Controller start-up

8.1 Switching on / soft start

After a careful check of the cables, connect the tool to the control unit.
Switch on the control unit at the main switch.
Use the arrow buttons to activate the set point display and enter the desired set point value.
The controller module is switched on with the I/O switch and the soft start is activated for 5 minutes
(factory setting) up to 120°C max. SOF appears in the set point value display.
The "Temperature deviation" alarm display will light up.
After the soft start has been completed, the pre-set set point value will be displayed.
The control unit now heats up the tool uniformly.
10 HASCO hot runner