Table of Contents
Advertisement
Using the Remote
Programming the Remote
The universal remote can be programmed to control most
brands of remote controllable VCRs, receivers, etc. The remote
is already programmed to control most RCA, GE and
PROSCAN TVs, VCRs, Laserdisc players and Satellite Receivers.
Testing the Remote
To determine whether the universal remote needs to be
programmed, turn a device on, such as a VCR, point the remote
at the VCR, and press the VCR1 button. Then press POWER or
CH
(channel up) or CH
responds to the remote commands. If not, the remote needs to
be programmed.
Programming the Remote to Control a VCR, Laserdisc
player, Satellite Receiver or Cable Box
Follow these steps to program your universal remote to control
a VCR, Laserdisc player, Satellite Receiver or Cable Box:
1. Turn on the component to be programmed.
2. Look up the brand and code number(s) for the component
on the code list on the last page of this section, Using the
Remote .
3. Press and hold the button on the remote you want to
program.
4. Enter the code from the code list.
5. Release button, and then press POWER to see if the
component responds to the remote commands. If it doesn't,
try pressing the component button and then POWER again.
6. If you get no response, repeat these steps using the next
code listed for your brand, until the component responds to
the remote commands.
20
(channel down) to see if the VCR
CHAN
VOL
VOL
CHAN
1
2
3
4
5
6
7
8
9
0
You'll use these buttons when you
program the remote to control any
device.
The remote may not operate all
models of all brands.
Advertisement
Table of Contents
