Table of Contents
Advertisement
Programming
the Remote
The universal
remote can be programmed
to control most
brands of remote controllable
VCRs, receivers, etc. The remote
is already programmed
to control most RCA, GE and
PROSCAN
TVs, VCRs, DVD players, laserdisc players and
satellite
receivers,
Testing
the Remote
To determine
whether
the universal
remote needs to be
programmed,
turn a device ON, such as a VCR, point the remote
at the VCR, and press the VCR1 button. Then press ON.OFF or
CH ^ (channel up) or CH v (channel down) to see if the VCR
responds to the remote commands,
If not, the remote needs to
be programmed.
Programming
the Remote
Using
Automatic
Code
Search
The following
instructions
can be used to program
the remote
to control each of the devices connected
to your TV. If you want
to exit the automatic
code search without
programming
any of
your devices, press and hold CLEAR until the LED turns off.
1.
Turn on the device you want to control
(VCR, SAT, etc,).
2.
Press and hold the button you want to program
(VCR1,
VCR2, etc.). Note that the AUX button can only be
programmed
with direct entry (see the next section for
details). While holding the device button, press and hold
ON.OFF until the red light on the remote turns on, then
release both buttons.
3.
Press and release PLAY, then wait 5 seconds or until the LED
stops flashing.
At this point the remote is searching
for the correct code to
program.
If, after 5 seconds, the device you want to control
does not turn off, press PLAY again to tell the remote to
search the next set of codes.
Continue
pressing
PLAY until the device turns off or you
have searched through
all of the codes. There are 20 total
sets of codes. If the device does not turn off after pressing
PLAY 20 times, then the remote cannot control that
particular
device,
If the device
you want
to control
does turn off:
1.
Press and release REVERSE, then wait 2 seconds. Repeat
this step until the device turns back ON.
22
You'll use these buttons when you
program the remote to control any
device.
The remote may not operate all
models of all brands.
Advertisement
Table of Contents
