Table of Contents
Advertisement
CLEANING
BEFORE CLEANING MAKE SURE THE MACHINE IS SWITCHED OFF,
UNPLUGGED AND ALLOWED TO COOL. Dualit recommends cleaning your Baby
Food Maker after every use. Do not submerge the Base, Power Cord or plug into
water or other liquid, or position under a water tap. Do not use sharp, abrasive
or aggressive cleaning agents, bleach or scouring pads to clean the Baby Food
Maker. The use of such cleaning implements may affect the life of the Baby Food
Maker. When not in use, clean and dry the Baby Food Maker and store in a cool, dry place.
1
2
Unplug the Baby Food
Remove the Blade Assembly
Maker from the mains
from the Blender Jar
and allow to cool down
following instructions on
completely before cleaning.
page 14. Caution: The
blade is sharp, risk of
injury.
4
5
Clean all surfaces of the
Wipe the external surfaces of the Base with
Blender Jar, Steaming Basket,
washing up liquid and a damp, soft cloth.
Caution: Do not use sharp articles or
Seal, Steaming Rack and Lid
with either washing up liquid
metal tools to touch the Hot Plate as it
and a damp, soft cloth or on
may cause electric shock.
the top shelf of the dishwasher.
3
Remove the Seal from the
Steaming Basket before
cleaning as food can build
up behind the Seal. Always
replace the Seal after
cleaning. Caution: Do
not operate without
the Seal in place, risk of
undercooked food.
22
CLEANING THE BLADE ASSEMBLY
Clean the Blade Assembly after every use as food can build up under the blade
on the Blade Assembly. Caution: A dirty blade will contaminate food that you
make in the future.
1
2
Remove the Blade Assembly
Rinse the Blade Assembly
from the Blender Jar
and Blade Seal under a tap
following instructions on
while carefully using the
page 14. Caution: The
Cleaning Brush to clean
blade is sharp, risk of
under the blades with
injury.
soap suds until all food
remnants are removed.
Once the food residue has
been removed, the Blade
Assembly can sit in the top
shelf of the dish washer.
Warning: Do not operate the Baby Food Maker unless the blade is securely in
position.
Caution: The blade is sharp, risk of injury. Always hold the Blade Assembly by
the Blade Hub.
3
Dry the Blade Assembly
with a lint-free cloth. Allow
to fully dry before replacing
back into the Blender Jar.
23
Advertisement
Table of Contents
