Removing The Ied; Sending The Ied For Repair; Exchanging The Ied - ABB SAM600-IO Installation Manual

Hide thumbs Also See for SAM600-IO:

Table of Contents

Section 8

Removing, repairing and exchanging

IEC17000158 V1 EN-US

Figure 16:

8.3

Removing the IED

Before removing the IED, make sure that auxiliary power is turned off and all wiring is disconnected.

8.4

In case of product problems, contact the nearest Hitachi Power Grids office or representative for

consultation and instructions.

8.5

To exchange the IED with another identical unit, remove the IED and install the new one. Contact

your local Hitachi Power Grids for information about exchangeable units.

IED summary

For upgrade purposes the IED does not need to be removed. Before removing the

IED check with your local Hitachi Power Grids office if the IED can be upgraded.

1MRK 514 030-UEN Rev. C

IEC17000158-1-en.vsdx

GUID-6F99E661-D319-4782-97E9-3A864B1E972D v3

GUID-1EB39784-696C-4B2E-B560-4115F721DCAB v10

Switchgear control unit SAM600-IO

Installation manual

AMU0600445 v5

Table of Contents