Figure 83. Removing the NDC riser
Next steps
1.
Install the NDC
riser.
Installing the NDC riser
Prerequisites
1. Follow the safety guidelines listed in
2. Follow the procedure listed in
Steps
1. Hold the Network Daughter Card (NDC) riser by its edges and align the connector on the NDC riser and guide pin on the
system board.
2. Insert the NDC riser until the card is fully seated.
3. Close the riser retention bracket and slide the bracket to lock the NDC riser.
Safety instructions
Before working inside your system
on page 29.
on page 30.
Installing and removing system components
99